January 2008

This is the rear trunk hinge and strap.

This shows the rear view, with the hinge bolt installed.

This shows the front plastic roof holder and the rear trunk seal. The seal is just pressed on.

This shows the rubber cap over the rear shock bolt/nut and the plastic cup that holds the front roof clamp.

This is the rear trunk latch, attached to the lid.

This is the rear trunk latch, attached to the body.

Wide angle shot of the rear trunk. I reinstalled the trunk torsion spring. Also installed is the wiring and the carpet.

Trunk lid and rear tail lights installed. On the floor is the rear valance.

Rear valance installed.

Rear bumper installed.

Rear trunk lock installed.

This shows where I glued the front trunk firewall carpet. This also shows the rubber seal that runs on top of the firewall.

A wide angle shot of the front trunk. This also shows the front trunk seal. I don't glue the seal in, so it's going to take awhile for the seal to lay in place correctly. BTW, the reason I don't glue the seal in is it's easier to check if there is any moisture, therefore, minimizing rust in this area.

A nice reference shot of the headlight mechanism.

A close up of the expansion tank and windshield washer bottle.

After removing the front trunk lid and bumpers for painting, I reinstalled them.

A nice shot of the front bumper installed. I also installed the front valance.