September 2009

Here I had to replace about 2 feet of the hood channel that holds the hood seal.

Here's a shot from the fenderwell showing the new piece attached and seam sealer applied.

Here's a shot of the right front fender. You'll notice that I welded up the side marker light holes. I stripped the paint and only put a light primer coat on now, I'm planning to work the outside body sections later.

This is a shot of the front section of the right front inner fender well.

This is a shot of the rear section of the right front inner fender well.

Here's a shot of the left front fender. Again, the side marker light holes have been filled.

A shot of the left front fender well.

A shot of the left rear fender well.

I also stripped the front hood.

I had to repair the front section of the longitudinal on the right side.

Another shot of the longitudinal repair.

I sprayed some rubberized undercoating on the inner fender wells, here's the right side.

Here's the left side.

Also sprayed undercoating on the front trunk.

And more undercoating in the steering rack area.